Elite The Protector Uživatelský manuál stáhnout pdf (Strana 3)

-3

6) How do I use my Remote?

Unless otherwise informed by your installer, you will need to press the Lock button

TWICE on the Remote to fully Arm the system. ONE press of the Unlock button is

all that is needed to Disarm.

You don’t need to press these buttons very hard, but rather press and hold until you

see the small light (top left hand corner) flash on your Remote.

To activate a ‘Panic Alarm’ from your Remote, press the Lock & Unlock buttons at

the same time and hold these buttons down for 3 seconds.

7) Can you tell me more about my Smoke Detector?

Your Smoke Detector has an indicator light that flashes about 4 times a minute.

(Some people never notice this light.) The Smoke Detector will indicate when its

batteries need replacing by sounding a short ‘beep’ every minute. When your Smoke

Detector activates, it has its own alarm sound. The Control Panel siren will also

sound & the Monitoring Centre will be notified. To stop the Smoke Detector

sounding, open doors/windows in this area & fan the smoke/steam away from the

Smoke Detector. Stop the Control Panel siren by entering your code at the Control

Panel or by pressing the Unlock button on your Remote.

Should you accidentally activate your Smoke Detector, it is crucial you make contact

with the Monitoring Centre to avoid an unnecessary response from the Fire

Department.

When vacuuming your home we recommend you also carefully vacuum the dust from

the black mesh area of the Smoke Detector.

Dust Motion Sensors regularly also, especially if you notice spider webs.

8) What if my Disarm Light is flashing?

If you notice the Disarm Light flashing, simply press this Disarm button and it will

stop.

9) What is the System Status Button/Light?

Normally when you are home and the Alarm is not Armed, the only button lit on the

Control Panel is the Disarm button. If the Control Panel has a message for you (an

Activation for example,) the System Status button will light up…

Press the System Status button : you will hear the Time, then any messages.

Pressing Disarm next, will clear these messages and the System Status Light will go

out if there is no current problem with the Alarm.

1 2 3 4 5 6 7 8 ... 19 20

Žádné komentáře

Elite The Protector Uživatelský manuál Strana 3